In this article, we will learn how to add an address to an existing installation
We start by going to 1. Order and click on the little arrow. In the list that opens, we select 2. Service:
Find either your 1. Installation site or 2. Equipment. In the example below, we have gone through 1. The installation location.
Then click on edit on the left:
A new image will now open where you select 1. Customer, 2. mark the address and 3. Edit address:
In the new image, you can navigate to the new address on the map by dragging around.
When you are in the right place, right click "hard" and three dots will appear; at the top, the address you have clicked on (so you can verify that you are in the right place), in the middle, only update the coordinates of the address, and at the bottom, update both the position and the address on the left.
We recommend that you always choose 'Update address and position' so that you get both the coordinates and the address displayed correctly:
If you right-click 'quickly' on the map, you will have the option to rotate the map. You can exit this by right-clicking hard again. Afterwards, you can drag the map around again and find the new address/position.
If you choose to go via 2. Equipment, the edited image will instead look like this:
Remember to press Done when you have updated everything you need.